DTC B0987
Diagnostic Instructions
DTC Descriptor
DTC B0987 05: Vehicle Direction Camera
Indicator Circuit High Voltage/Open |
Diagnostic Fault Information
Circuit
|
Short to Ground
|
Open/High Resistance
|
Short to Voltage
|
Signal Performance
|
Lane Departure Warning Switch Indicator Ignition
|
B0987 05
|
B0987 05
|
-
|
-
|
Lane Departure Warning Switch Indicator Control
|
-
|
B0987 05
|
B0987 05
|
-
|
Lane Departure Warning Switch Ground
|
-
|
B356A 05
|
-
|
-
|
|
|
Circuit/System Description
The lane departure warning is enabled and disabled through a
switch located in the multifunction switch at the instrument panel.
When enabled, the vehicle direction camera control module will
illuminate the indicator located in the switch.
Conditions for Running the DTC
Ignition ON
Conditions for Setting the DTC
The vehicle direction camera control module has detected a short
to battery or open.
Action Taken When the DTC Sets
• |
Lane departure warning is
disabled. |
• |
SERVICE LANE DEPARTURE SYSTEM
is displayed on the driver information center. |
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present.
Reference Information
Schematic Reference
Object Detection Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Object Detection Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
1. |
Verify DTC B356A is not
set. |
2. |
Verify DTC B0987 is not
set. |
⇒ |
If DTC is set, refer to Circuit/System
Testing. |
Circuit/System Testing
1. |
Ignition OFF, disconnect the
harness connector at the K74 Vehicle Direction Camera Control
Module and the harness connector at the S48D Multi-Function Switch
2 - Instrument Panel. |
2. |
Ignition ON, test for greater
than 11 V between the ignition circuit terminal 3 at the S48D
Multi-Function Switch 2 - Instrument Panel harness connector and
ground. |
⇒ |
If less than the specified value, test the
ignition circuit for a short to ground or an open/high
resistance. |
3. |
Test for less than 0.3 V
between the control circuit terminal 8 at the S48D Multi-Function
Switch 2 - Instrument Panel harness connector and ground.
|
⇒ |
If greater than the specified value, test the
control circuit for a short to voltage. |
4. |
Ignition OFF, test for
infinite resistance between the control circuit terminal 8 at the
S48D Multi-Function Switch 2 - Instrument Panel harness connector
and ground. |
⇒ |
If less than the specified value, test control
circuit for a short to ground. |
5. |
Test for less than 5 Ω
between the S48D Multi-Function Switch 2 - Instrument Panel control
circuit terminal 8 and the control circuit terminal 4 at the K74
Vehicle Direction Camera Control Module harness connector
|
⇒ |
If greater than the specified value, test the
control circuit for an open/high resistance. |
6. |
If all circuits test normal,
connect the harness connector to the K74 Vehicle Direction Camera
Control Module, replace the S48D Multi-Function Switch 2 -
Instrument Panel and verify the DTC does not reset. |
⇒ |
If the DTC resets, replace the K74 Vehicle
Direction Camera Control Module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
|