Remote Control Door Lock Transmitter Programming
Next Available Slot
Note:
• |
On some vehicles, keyless
entry transmitters may also be programmed using the information
center. Refer to the vehicle owners manual for information.
|
• |
Do not operate or program the
transmitters in the vicinity of other vehicles that are in the
keyless entry program mode. This prevents the programming of the
transmitters to the incorrect vehicle. |
This procedure will program keyless entry transmitters in
sequential order. If two transmitters are currently learned to the
vehicle as transmitters 1 and 2, using this procedure will
learn the next transmitter as transmitter 3, and so on.
- With a scan tool, access the Body Control Module Setup
menu. Select Program Key Fobs.
- Select Next Available Slot. The vehicle chime will
sound two times to indicate programming mode has been entered.
Follow the on-screen instructions. After each transmitter has been
programmed, the vehicle chime will sound to confirm the
programming.
- When all the desired transmitters have been
programmed, cycle the ignition from ON to OFF, exit the vehicle,
and operate the transmitter functions in order to verify correct
system operation.
Invalidate All Fobs
Note:
• |
On some vehicles, keyless
entry transmitters may also be programmed using the information
center. Refer to the vehicle owners manual for information.
|
• |
All transmitters which are to
be recognized by the keyless entry control module and the body
control module (BCM) must be programmed in a single programming
sequence. Once the Invalidate All Fobs selection is made, all
learned transmitters are erased. If all existing transmitters
associated with the vehicle are not learned at this time, they will
become inoperative and require additional programming. |
• |
Do not operate or program the
transmitters in the vicinity of other vehicles that are in the
keyless entry program mode. This prevents the programming of the
transmitters to the incorrect vehicle. |
This procedure will first erase all known keyless entry
transmitters. After all transmitters are erased, the procedure will
begin to program keyless entry transmitters in sequential order,
beginning with transmitter 1.
- With a scan tool, access the Body Control Module Setup
menu. Select Program Key Fobs.
- Select Invalidate All Fobs. This will erase all
learned transmitters and prepare the BCM to learn new transmitters.
Follow the on-screen instructions. After each transmitter has been
programmed, the vehicle chime will sound to confirm the
programming.
- When all the desired transmitters have been
programmed, cycle the ignition from ON to OFF, exit the vehicle,
and operate the transmitter functions in order to verify correct
system operation.
Transmitter Slot Programming
Transmitter slot programming allows a single transmitter to be
programmed into a specific slot without affecting any of the other
programmed transmitters. By using slot programming, the transmitter
originally programmed to a specific slot is erased and the new
transmitter is learned in its placed.
- Install a scan tool.
- Turn ON the ignition with the engine OFF.
- With the scan tool, select Body.
- Select body control module (BCM).
- Select Module Setup.
- Select Program Key Fobs.
- Select the key fob desired to be programmed.
- Follow the scan tool on screen instructions.
- Remove the scan tool.
- Exit the vehicle. Operate all functions on
transmitters to verify correct system operation.
|