Steering Wheel Inflatable Restraint Module Replacement
Removal Procedure
Warning: Refer to
SIR Inflator Module Handling and Storage
Warning .
Warning: Refer to
SIR Warning .
|
Note: Produce a
special tool for airbag removal, the tool can be reused.
|
2. |
Use a screwdriver or
equivalent tool with total length of (b) 180 mm (7.1 in) and a
diameter of 3-4 mm (0.1-0.15 in). Bend the tip (a) at 30 mm (1.2
in) by approx. 30 degrees. |
3. |
Lower the steering column and
move to the maximum rear end position. |
4. |
Turn the steering wheel to a 3
o'clock and 9 o'clock position so that the holes are at the
top. |
5. |
Insert the screw driver (1)
through both access openings and push the spring fastener (2)
inward to release the steering wheel inflator from the steering
wheel. |
6. |
Open secondary locking
(2). |
7. |
Disconnect the electrical
connectors (1). |
8. |
Remove the steering wheel
inflatable restraint module (2). |
Installation Procedure
1. |
Connect the electrical
connectors (1). |
2. |
Close secondary
locking. |
3. |
Align the inflatable restraint
module fasteners to the steering wheel spring fastener (3).
|
4. |
Push the inflatable restraint
module (2) firmly into the steering wheel in order to engage the
spring fastener (3). |
|