Manual Shift Detent Lever with Shaft Position Switch Assembly
Replacement
Special Tools
DT-41229 Manual Shaft Pin Installer
For equivalent regional tools, refer to
Special Tools .
Removal Procedure
2. |
Remove the manual shaft detent
lever hub pin (1) using a pry bar and pliers. |
3. |
Remove and DISCARD the manual
shift shaft pin (5). |
4. |
Remove the manual shaft
(2). |
5. |
Disconnect the actuator rod
(3) from the detent lever assembly. Do not remove the actuator rod
from the transmission case. |
6. |
Remove the manual shaft detent
(with shift position switch) lever assembly (4). |
Installation Procedure
1. |
Connect the actuator rod (3)
to the detent lever assembly. |
2. |
Install the manual shaft
detent (with shift position switch) lever assembly (4).
|
3. |
Install the manual shaft
(2). |
4. |
Install the manual shaft
detent lever hub pin (1) to height of 7.9 mm (0.38
in) (b). |
|
Caution: Use J 41229 to install the manual shaft pin at the
correct height in order to properly secure the manual shaft. If you
install the pin too deep, the case bore may crack. |
5. |
Install the NEW manual shift
shaft pin (5) using DT-41229 pin installer . Use a
NEW pin to ensure proper engagement with the case. |
6. |
Inspect pin installed height
is within 7.2-8.2 mm (0.28-0.32 in)
(a). |
|