2-6 Clutch Piston Installation (6T40/45/50)
Callout
|
Component Name
|
1
|
2-6 Clutch Piston Assembly
Tip
| • |
Position the 2-6 piston air
bleed and large slot toward the top of the case. |
| • |
DT-47796 seal
protector prevents the piston seal lip from damage during
installation. Apply a thin coat of ATF to the I.D. of the
DT-47796 seal protector to ease installation of the
piston. |
Special Tool
DT-47796 Seal Protector
For equivalent regional tools, refer to
Special Tools .
|
2
|
2-6 Clutch Spring
|
3
|
2-6 Clutch Spring Retainer
|
Caution: Regulate the air pressure to 276 kPa (40 psi) maximum.
High pressure could cause the piston to over travel and damage the
piston seals. |
Tip
| • |
Place the retainer on the 2-6
clutch spring and align the retainer opening with the largest gap
in the case splines toward the bottom of the case. The retainer
opening should be supported by a spline tooth of the case.
|
| • |
Apply shop air to the clutch
fluid feed hole in the case to verify proper piston
operation. |
Special Tools
| • |
DT-47797 Spring Installer |
| • |
DT-48056 Spring Compressor
Bridge |
For equivalent regional tools, refer to
Special Tools .
|
|
| |
|
