Manual Transmission Shift Lever and Selector Lever Cable
Adjustment
Special Tools
DT-527-A Adjuster
For equivalent regional tools, refer to
Special Tools .
Removal Procedure
| 2. |
Clip instrument panel lower
center compartment liner (2) out of front floor console.
|
| 3. |
Unlock shift lever and
selector lever cable adjust locks (1). |
| 4. |
Press 2 latches
(arrows). |
| 5. |
Slide transmission control
lever retainer (2) upwards. |
| 6. |
Remove transmission control
lever knob (1). |
|
Note: The 2 pins (2)
have to engage into the 2 holes (3).
|
| 7. |
Turn transmission control
lever knob (1) 180° and install to transmission control
lever. |
| 8. |
Remove engine control module
from battery tray and lay aside. |
| 9. |
Block transmission control
housing (1) using DT-527-A adjuster (2).
|
Installation Procedure
| 1. |
Lock shift lever and selector
lever cable adjust locks. |
| 2. |
Turn and install transmission
control lever knob (1). |
| 3. |
Slide transmission control
lever retainer downwards. |
| 4. |
Remove DT-527-A
adjuster from transmission control housing. |
| 5. |
Install engine control module
to battery tray. |
| 6. |
Clip instrument panel lower
center compartment liner (2) into front floor console. |
|
