Left Hand Engine Damping Block, Replace (Z 17 DTH,
With Air Conditioning, LHD)
Remove
2. |
Disconnect battery
Important: In vehicles as of
model year 04 with ESP - every time the battery is disconnected,
the steering angle sensor loses its basic setting and must be
recalibrated
|
• |
Ground cable
|
|
3. |
Detach fuel filter
Note: Pull out of crash
box
• |
Disconnect wiring harness plug
|
|
4. |
Remove coolant compensation tank
• |
Remove clip
Note: Remove from
bracket and set aside
|
|
6. |
Unclip wiring harness on air intake pipe
|
|
7. |
Attach engine bridge MKM-883-1
Note: Follow
manufacturer's instructions, 2nd mechanic is required.
• |
Prevent from tilting with MKM-883-3
(2) and (3)
|
|
Warning: Comply with manufacturer's
instructions
|
8. |
Attach engine
Note: Attach MKM-883-1 to 2 engine transport shackles
(arrows). Tighten tensioning chains, do not lift engine during this
process.
|
|
10. |
Release front reaction member
• |
Undo bolted connection (arrow)
|
|
|
|
11. |
Remove exhaust system
Important: When removing the
centre muffler, a catalytic converter, an exhaust manifold or an
exhaust manifold with catalytic converter, secure the part of the
exhaust system that remains on the vehicle against uncontrolled
sagging. The exhaust system piece with the flex pipe inside can be
secured to the vehicle underbody for this purpose using suitable
material such as wire . Bends in the flex pipe with an angle of as
little as 5 – 10 degrees from the intended installation
position may result in damage with subsequent total failure of the
flex pipe
|
• |
Remove front exhaust pipe
|
|
|
|
12. |
Attach exhaust system
Note: Second person
required
|
13. |
Release rear reaction member
• |
Unscrew bolted connection (arrow)
|
|
|
|
15. |
Release left engine damping block adapter
|
16. |
Remove left engine damping block bracket
|
17. |
Lower engine
Note: Do not damage
attaching parts. Lower engine until just before the point where the
transmission rests on the front axle body
|
18. |
Remove left engine damping block
|
|
|
Install
19. |
Install left engine damping block
|
20. |
Install left engine damping block bracket
|
22. |
Fasten left engine damping block adapter
• |
Tighten 2 new bolts 80 Nm + 60° -
75°
|
|
24. |
Fasten rear reaction member
|
25. |
Attach front reaction member
|
26. |
Attach exhaust system
Note: Second person
required
• |
Attach retaining rubber (5x)
|
|
27. |
Fasten front exhaust pipe
• |
Tighten 3 new nuts 25 Nm
|
|
29. |
Remove MKM-883-1
Note: 2nd person
required. Remove tensioning chains from engine.
|
30. |
Clip wiring harness on to air intake pipe
|
32. |
Attach coolant compensation tank
|
35. |
Program volatile memory
|
|