Right Hand Engine Damping Block, Replace (Z 17
DTH, With Air Conditioning, LHD)
Remove
2. |
Remove air cleaner housing
|
4. |
Remove ribbed V-belt cover
|
|
|
|
5. |
Attach KM-6394
• |
Position KM-6394 (1) at the front on
the front axle body
Note: Both locating
pins (arrows) must be seated in the holes in the front axle
body
|
• |
Push front bracket (2) in the direction of the arrow
|
• |
Place rear bracket (4), right hand side, on front axle body
|
• |
Attach rear bracket (3), left hand side
|
|
|
|
6. |
Install support
• |
On KM-6394
– |
Adjust bracket (2) for support
|
|
|
7. |
Adjust 3x support
• |
Transmission side
Note: Turn spindles
until mounts (3) are positioned at guide journals free of play
|
• |
Engine timing side
– |
Insert journal of the support in the bore of the cylinder block
free of play (arrow)
|
|
|
|
9. |
Remove right engine damping block (1)
|
|
|
Install
10. |
Install right engine damping block
• |
On engine bracket
– |
Tighten 2 bolts 60 Nm + 30° +
15°
|
|
|
14. |
Attach ribbed V-belt cover
|
16. |
Install air cleaner housing
|
|