Replace rear crankshaft seal ring (Z 12 XE, Z 12
XEP, Z 14 XEP)
Remove
1. |
Remove transmission - See operation "Removing and installing
transmission" or "Removing and installing automatic transmission"
in group "K"
|
2. |
Detach clutch - see operation "Remove and install thrust plate
and clutch disk" in group "K"
|
|
|
4. |
Remove crankshaft rear seal ring
• |
Place collecting basin underneath.
|
• |
Lever out crankshaft rear seal ring
Note: Do not damage
sealing surface
|
|
|
|
Install
6. |
Install rear crankshaft seal ring
• |
Coat sealing lip with silicone grease
|
• |
Position KM-235-6 (2) on crankshaft
journal
|
• |
Slide seal ring (1) onto KM-235-6
|
• |
Drive in until flush using KM-658-1
(3)
|
|
7. |
Attach flywheel
• |
Clean threads in crankshaft
|
• |
Tighten bolts 35 Nm + 30°
|
|
8. |
Insert guide bush into crankshaft
|
|
|
9. |
Attach clutch - see operation "Remove and install thrust plate
and clutch disk" in group "K"
|
10. |
Check engine oil level and correct if necessary
|
|
|
|