Fuel Filter, Replace (Petrol Engines)
Warning: Fuel
escapes – observe safety measures and national legislation.
Dispose of fuel collected - observe disposal and safety
legislation.
Note: The special
tool used in the operation below is particularly well suited to
fulfilling the safety regulations and national legislation. It can
be obtained from the address below under the designation "Device
for changing the fuel filter", article number 600250:
F. Boge GmbH
|
Postfach 1229
|
D-36396 Steinau a.d. Str.
|
Germany
|
Remove
1. |
Remove air guide plate, underbody
Note: For "ECO" model
version
|
2. |
Detach fuel filter in holder
• |
Remove screw (1)
Note: Graphics show the
"Combo" model variant (F06, F25).
|
|
|
|
3. |
Attach head of the special tool (1) to the fuel filter (2)
• |
Threaded pipe (3) points downwards
|
• |
Press the entire surface of the rubber gasket (arrow) against
the fuel filter housing
– |
Adjust turnbuckle accordingly
|
– |
Hold in place with clamp
|
|
|
|
|
4. |
Attach fuel collection tank (3) to the head of the special tool
(1)
Warning: Fuel filter is
pressurised. Check that special tool is fitted firmly.
|
• |
Screw fuel collection tank to threaded pipe and screw in
place.
Note: The integral bit
drills into the fuel filter housing. The escaping fuel flows into
the collecting container.
|
|
5. |
Vent fuel filter
Warning: Follow the sequence of
operations specified.
|
• |
Perforate as high as possible (arrow) using the pliers (5)
supplied with the special tool
|
|
6. |
Remove 2x fuel line (2, 4) from fuel filter and seal
Warning: Do not remove the fuel
lines until no more fuel is escaping from the fuel filter. Fuel
escapes - observe safety regulations and national legislation.
|
• |
remove with KM-796-A at quick release
fitting
|
|
|
|
7. |
Remove special tool when the fuel filter is empty
• |
Detach head of the special tool
|
|
Install
9. |
Insert 2x new connecting clips (1) in the socket of the quick
release fitting for the fuel line (2)
|
10. |
Insert a new fuel filter
• |
Push into holder from the front
Note: Note direction of
throughput
|
|
11. |
Connect 2x fuel line (4, 5) to fuel filter
• |
Connect 2x fuel line with quick release fitting to fuel
filter
|
• |
Perform tensile test
Note: Ensure that the
quick-release fittings are correctly engaged
|
|
12. |
Fix fuel filter in holder
|
|
|
13. |
Install air guide plate underbody
Note: For "ECO" model
version
|
14. |
Check 2x quick release fitting of the fuel line on the fuel
filter for leaks
Note: with the engine
running
|
|