Kinematic gears air distribution - replace ECC
(LHD)
Remove
1. |
Remove instrument panel padding
|
2. |
Remove servo motor kinematic plate (1)
• |
Disconnect wiring harness plug (2)
|
|
|
|
3. |
Remove kinematic plate (1)
|
|
|
4. |
Remove temperature sensor (1) air outlet headroom
• |
Disconnect wiring harness plug (2)
|
|
|
|
5. |
Kinematic gears air distribution - remove
• |
Remove defroster cam (1)
|
• |
Release defroster lever (2) (arrow) and remove
|
• |
Remove kinematic gear defroster (3)
|
• |
Release kinematic gear ventilation (5) (arrow) and remove
Note: Use angled
screwdriver or similar tool to release.
|
• |
Release kinematic gear footwell (4) (arrow) and remove
|
|
|
|
Install
|
6. |
Kinematic gears air distribution - install
Note: The kinematic
gears are coded and can only be installed in one position. Before
installation, highlight the corresponding marking to facilitate
positioning.
• |
Kinematic gear footwell (2) - insert
|
• |
Kinematic gear ventilation (3) - insert
|
• |
Kinematic gear defroster (1) - insert
|
|
|
|
7. |
Install cam, kinematic air distribution
• |
Insert defroster lever (1)
|
• |
Insert defroster cam (2)
Note: Note marking on
defroster gear (4) for correct position. Before installation,
highlight the corresponding marking (arrows). The bore in the cam
and the defroster gear (3) must align.
|
|
|
8. |
Install kinematic plate
|
9. |
Fit servo motor kinematic plate
• |
Fix wiring harness plug
|
|
10. |
Install temperature sensor, air outlet headroom
• |
Fix wiring harness plug
|
|
11. |
Install instrument panel padding
|
|