|
Cylinder Head, Check for Plane Surface
 Remove
| 1. |
Detach attaching parts from cylinder head 
|
| 2. |
Clean sealing surface and remove sealant residue
|
| 3. |
Check cylinder head on the sealing surfaces for sag along their
length and width and in the diagonals for distortion
| • |
Use straightedge and feeler gauge
|
|
| 4. |
Measure height of cylinder head
| • |
Sealing surface to sealing surface
|
| • |
Measurement I: = 105.45 - 105.55
mm
|
|
|
|
Install
| 5. |
Attach attaching parts to cylinder head
|
|
