Check and adjust valve play
Remove
1. |
Detach injectors
Note: Mark which is
which
|
2. |
Turn the crankshaft until the cam pair (1) and (2) faces
upwards.
|
|
|
3. |
Check valve play with feeler gauge (1)
Note: The valve
clearance is checked with the engine cold - room temperature.
• |
Test values: see Technical Data
|
|
|
|
4. |
Turn crankshaft
• |
180° in direction of engine rotation
– |
Check valve play at cam pair (6) and (2)
|
|
• |
180° in direction of engine rotation
– |
Check valve play at cam pair (5) and (3)
|
|
• |
180° in direction of engine rotation
– |
Check valve play at cam pair (4) and (1)
|
|
• |
Test values: see Technical Data
|
|
|
|
6. |
Remove cup tappets using KM-845
|
Install
7. |
Determine the size of the cup tappet
Note: The
identification number (arrow) is located on the inside of the cup
tappet
Example of how to calculate the size of the cup
tappet:
|
|
|
|
Size of the installed cup tappet
|
|
3.66 mm
|
(code 66)
|
Measurement between cams and cup tappets
|
+
|
0.44 mm
|
|
|
=
|
4.10 mm
|
|
Desired valve lash, intake side
|
-
|
0.40 mm
|
|
Nominal size of the new cup tappet
|
|
3.70 mm
|
(code 70)
|
Note: For code
allocation, see Technical Data
• |
Now use a cup tappet with this dimension or one that is nearest
to it
|
|
|
|
8. |
Install valve lifters
Note: Coat cup tappet
with engine oil and insert
|
10. |
Check valve play again with feeler gauge
|
|