|
Engine oil with oil filter change
 Remove
| 2. |
Remove air cleaner housing (1) with air intake hose (5)
| • |
Disconnect 2x wiring harness plugs (2)
|
| • |
Remove air intake hose from turbocharger
|
| • |
Detach oil separator hose from air intake hose
|
| • |
Detach water drain hose from lower part of air cleaner
housing
| – |
Pull off hose from air cleaner housing
|
|
| • |
Detach air cleaner housing from wheel housing
| – |
Press out from rubber retainer in 3 places
|
|
|
|
|
| 3. |
Place collecting pan underneath.
|
| 4. |
Remove oil filter element
| • |
Remove oil filter housing cover (1)
|
| • |
Replace oil filter element (2)
|
| • |
Replace seal ring, oil filter housing cover (3)
|
|
|
|
| 5. |
Raise vehicle by its full height
|
| 6. |
Drain engine oil
| • |
Place collecting pan underneath.
|
|
Install
| 8. |
Lower vehicle by its full height
|
| 9. |
Install oil filter element
| • |
Install oil filter housing cover
| – |
Tighten cover of oil filter housing 25
Nm
|
|
|
| 10. |
Install air cleaner housing with air intake hose
| • |
Attach water drain hose to air cleaner housing
| – |
Reconnect water drain hose
|
|
| • |
Attach air cleaner housing to wheelhouse
| – |
Press into rubber retainers in 3 places
|
|
| • |
Attach air intake hose to turbocharger
|
| • |
Attach oil separator hose to air intake hose
|
| • |
Push on 2x wiring harness plug
|
|
| 11. |
Top up engine oil
| • |
Observe specified engine oil quantity
|
| • |
Start engine and allow to run until oil pressure control
indicator goes off
|
| • |
Check engine oil level, correct if necessary
|
|
|
