Con-rod Bearing, Replace
Remove
2. |
Mark order of con-rod bearing caps (1)
|
|
|
3. |
Remove con-rod bearing caps from con-rods
Note: The mating
surfaces of the con-rods and con-rod bearing caps form an
individual fit and should never be swapped over or damaged. To
avoid damage, do not put the con-rods and con-rod bearing caps down
on the mating surfaces.
• |
Note installation position - bead (arrow) on the con-rod
bearing cap points towards the transmission side
|
|
4. |
Clean and check all the components, replace if necessary
|
Install
5. |
Insert new con-rod bearing shell
|
6. |
Attach con-rod bearing caps to con-rods
Note: Note installation
position - bead on the con-rod bearing cap points towards the
transmission side.
• |
Tighten 8x bolt 13 Nm + 60° +
15°
Important: Only use bolts of size
M6.5.
|
– |
Use new bolts
|
|
|
|