vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Resonator, Replace > < Fuel Pressure, Check

Replace air cleaner housing

  Remove

1.   Remove air cleaner housing
•   Disconnect hot film mass air flow meter wiring harness plug (1)
•   Detach engine vent hose from air intake pipe
Release clamp (2)
•   Detach air intake pipe from throttle valve module
Release clamp (3)
•   Pull air intake pipe (4) from air cleaner housing
•   Press air cleaner housing from rubber bearings
Push air cleaner housing upward (arrow)
Push air cleaner housing inward (arrow)
Object Number: 13408756  Size: DEFAULT


2.   Remove attaching parts
Note:   The stages below are only to be undertaken when replacing the air cleaner housing.
•   Detach air intake pipe
Release clamp
•   Detach upper part of air cleaner housing
Unscrew 4x bolts
•   Take out air filter insert

  Install

3.   Fit attaching parts
Note:   The stages below are only to be undertaken when replacing the air cleaner housing.
•   Place air cleaner insert in lower part of air cleaner housing
•   Attach upper part of air cleaner housing to lower part of air cleaner housing
Tighten 4x bolts
•   Attach air intake pipe
Fasten clamp
4.   Install air cleaner housing
•   Insert air cleaner housing into rubber bearing
•   Push air intake pipe onto air cleaner housing
•   Attach air intake hose to throttle valve module
Fasten clamp
•   Attach engine vent hose to timing case
Fasten clamp
•   Connect hot film mass air flow meter wiring harness plug

Resonator, Replace > < Fuel Pressure, Check