Field Remedy: 2043
Subject: |
Engine Z13DTJ/H - Diesel particulate
filter system DTC P1901(7) set together with P2003(7) |
Models: |
Engines: |
Option: |
Meriva 2006,Corsa-C 2006...,Corsa-C Combo
2006...2007 |
Z13DTJ,Z13DTH| Z13DTJ,Z13DTH| Z13DTJ |
|
Complaint: |
SVS light up and DTC: P1901(7) as well as
P2003 (7) are set, DPF is clogged. |
Cause: |
Multiple overload of DPF mainly due to
excessive short distance driving. |
Production: |
Introduction of modified software in
production as of the following breakpoints: Meriva Z13DTJ
(Zaragoza): W0L0XCE7574035026 Corsa Z13DTJ (Zaragoza):
W0L0SDL6874090884 Corsa Z13DTH (Zaragoza): W0L0SDL6874103286 Corsa
Z13DTJ (Eisenach): W0L0SDL0876039715 Corsa Z13DTH (Eisenach):
W0L0SDL0876044250 Combo Z13DTJ MT5 (Azambuja): W0L0XCF2573017184
Combo Z13DTJ MTA (Azambuja): W0L0XCF2573017364 |
Remedy:
In case of customer complaint be aware of the following:
Once the DTC: P1901(7) is set in COMBINATION with P2003(7) Tech 2
will not allow performing a service regeneration.
This functionality was blocked due to the risk of a thermal incident.
In case the DTC´s were erased by Tech 2 a service regeneration will
be possible again but is not recommended because of mentioned
possible consequences. The only solution is to replace the DPF.
Please do not forget to record DPF replacement in ECU.
It is essential to resolve the cause of the clogged DPF
(refer to TSB 1976) and/ or to check driving profile
(e.g. excessive short distance driving).
Note:
In case of customer complaint ask customer about personal driving
pattern. In case of unfavourable customer driving profile advice
customer that the diesel particulate filter needs regeneration
(cleaning). This only works when a certain profile is applied,
e.g. driving approximately 15 minutes when engine is warm. In order
to avoid damages to the DPF system customer has to ensure that
approximately all 500 km a proper regeneration will take place.
As of TIS 2000-DVD, version 75 a new SPS software is available which
will advice the customer with a flashing glow indicator in
instrument to change driving pattern (as mentioned in the
service manual).
Note:
Do not replace any parts!
FunctionalGroup: |
J - Engine |
Complaint Group: |
08 - Hard to operate |
Trouble Code: |
P1901(7),P2003(7) |
|