vauxhall Workshop Repair Guides

Vauxhall Corsa D Workshop Manual and Auto Repair Service

ABOUT US
Replace planetary gear P1 (AF13-II) > < Solenoid Valves, Check (AF13-II)

Replace Automatic Transmission Fluid Cooler for Corsa D AF 13-II - Step-by-Step Repair Guide

Replace automatic transmission fluid cooler (AF 13-II)

  Remove

1.   Detach 2 fluid cooler lines from transmission
Note:   Place collecting pan underneath.
•   Pull off 2 protective rings (3)
•   Prise off 2 retaining clamps (4)
Note:   Prise retaining clamp from quick-release connection with a small screwdriver
•   Pull off 2 fluid cooling lines
2.   Remove 2 fluid cooler lines on the fluid cooler
•   Pull off 2 protective rings (2)
•   Prise off 2 retaining clamps (1)
Note:   Prise retaining clamp from quick-release connection with a small screwdriver
•   Pull off 2 fluid cooler lines and remove
Note:   Note installation position of fluid cooler lines.
Object Number: 10679610 Size: DEFAULT


3.   Detach fluid cooler from transmission
•   Unscrew 2 nuts (1)
•   Unscrew bolt (2)
Object Number: 10678068 Size: DEFAULT


4.   Open coolant expansion tank cover
5.   Drain coolant
•   Place collecting basin underneath.
•   Push on suitable hose (2)
•   Open drain cock (1) in the direction of the arrow
•   Collect coolant
•   Close drain cock
Object Number: 10678410 Size: DEFAULT


6.   Remove fluid cooler (3)
•   Detach 2 coolant hoses (1)
– Undo 2x clamps (2)
Object Number: 10679625 Size: DEFAULT


  Install

7.   Install fluid cooler (3)
•   Attach 2 coolant hoses (1)
– Fasten 2 clamps (2)
Object Number: 10679625 Size: DEFAULT


8.   Attach fluid cooler to transmission
•   Tighten 2 nuts (1) 20 Nm
•   Tighten bolt (2) 20 Nm
Object Number: 10678068 Size: DEFAULT


9.   Attach 2 fluid cooler lines to the fluid cooler
Note:   Use new seal rings.
•   Insert 2 retaining clamps (1)
•   Insert 2 fluid cooling lines
Note:   Ensure that the fluid cooling lines engage audibly.
•   Push on 2 protective rings (2)
10.   Attach 2 fluid cooler lines to transmission
Note:   Use new seal rings.
•   Insert 2 retaining clamps (4)
•   Insert 2 fluid cooling lines
Note:   Ensure that the fluid cooling lines engage audibly.
•   Push on 2 protective rings (3)
Object Number: 10679610 Size: DEFAULT


11.   Fill and bleed cooling system LUREF_1.gif
12.   Transmission Fluid Level, Check and Correct LUREF_1.gif

Replace planetary gear P1 (AF13-II) > < Solenoid Valves, Check (AF13-II)