|
Drive Shaft, Replace (F17+/F17+ MTA)
Note: Transmission
remains installed.
 Remove
|
| 1. |
Remove gearshift cover (1)
Note: For transmission
F17+
Remove shift module
Note: For transmission
F17+ MTA
|
| 2. |
Remove reversing lamp switch (2)
| • |
Disconnect wiring harness plug for reversing lamp switch
|
| • |
Unscrew reversing lamp switch
|
|
| 3. |
Remove end shield cover (3) 
|
|
| 5. |
Remove drive shaft (1)
|
|
|
Install
Important: If gear cluster teeth
are damaged, always check the corresponding gear on the main shaft
and replace if necessary.
|
| 6. |
Install drive shaft (1)
|
|
| 7. |
Install end shield (1)
Note: Observe the
magnet
|
| 8. |
Install end shield cover (2)
|
| 9. |
Install gearshift cover (3)
Note: For transmission
F17+
Install shift module
Note: For transmission
F17+ MTA
|
| 10. |
Transmission Fluid Level, Check and Correct
|
| 11. |
Install reversing lamp switch (4)
| • |
insert with new seal ring
|
| • |
Tighten reversing lamp switch 20
Nm
|
| • |
Connect wiring harness plug
|
|
| 12. |
Check ease of gear shifting
|
|
|
