Adjusting specification, differential tapered
roller bearing (F13+)
Note: Adjust bearing
pre-load by screwing in the bearing ring.
Remove
1. |
Check starting torque with MKM-536-A
(1) and KM-6037 (2)
Important: Obey indicated
starting torques.
|
• |
Test speed is 1 revolution per second
Repair situation
|
Transmission removed starting torque (Nm)
|
1)
|
Adjustment after marking.
Reuse of all removed parts.
|
Place bearing ring on marking
|
2)
|
Reuse of bearing, replacement of bearing ring, bearing flange
and differential housing or transmission case.
|
0,60...1,00
|
3)
|
Bearing as new part
|
1,50...2,10
|
|
|
|
|
Install
2. |
Clean threads for screw locking plate in transmission case
|
3. |
Install locking plate bearing ring
• |
Tighten screw 9 Nm
Note: Insert screw with
locking compound
|
|
|