|
Transmission Fluid Level, Check and Correct
(F13+/F17+)
Note: Account must be
taken of the fact that ex works the transmission fluid level may
always be below the checking aperture – up to approx. 20 mm . The transmission fluid level need
only be checked and corrected, if necessary, after repair and
maintenance operations on the transmission.
 Remove
| 1. |
Remove fluid check bolt (arrow)
Note: Inspection
aperture on rear left in direction of travel.
|
|
|
| 2. |
Check transmission fluid level
Note: Transmission must
be filled up to the lower edge of the inspection aperture.
|
| 3. |
Remove reversing lamp switch (1)
Note: Only if
transmission fluid needs to be topped up.
| • |
Disconnect wiring harness plug, reversing lamp switch
|
|
|
|
| 4. |
Top up with transmission fluid until it emerges at the
inspection aperture
|
Install
| 5. |
Attach fluid check bolt to transmission
| • |
Tighten bolt 4 Nm + 45° to 135°
|
|
| 6. |
Attach reversing light switch to transmission with new seal
ring
| • |
Connect wiring harness plug for reversing lamp switch
|
|
|
