Replace engine compartment electronics (UEC)
Important: When
replacing the control unit, before removing the control unit carry
out a "Reset" using TECH 2.
Remove
2. |
Loosen fuse box
• |
Disconnect positive terminal (1)
|
• |
Unclip fuse box and put aside
|
|
|
|
4. |
Remove engine compartment electronics module
• |
Open cover (1)
Note: Pay attention to
removal notice on cover
|
• |
Remove positive cable with gasket
|
• |
Remove module from bracket
– |
Release module, rotate clockwise and remove, see arrow.
|
|
• |
Release 3 compact plugs (3) and disconnect
|
|
|
|
Install
5. |
Install engine compartment electronics module
• |
Connect and lock 3 compact plugs
|
• |
Insert engine compartment electronics module in bracket.
– |
Rotate module anti-clockwise
Note: Module must
audibly latch.
|
|
• |
Insert wiring harness with gasket
|
|
7. |
Attach fuse box
• |
Tighten bolt on positive terminal
|
|
9. |
Program volatile memories
Note: When replacing
the control unit, after installing the control unit, execute
"Program" with TECH 2.
|
|