|
Rear Park Pilot Control Unit, Replace L08
 Remove
| 2. |
Remove luggage compartment mat
|
| 3. |
Fold down rear-seat back
|
| 4. |
Remove lower tailgate inner panelling (2)
| • |
If present, unclip panel (1), Flex Fix System operating
handle
|
|
|
|
| 5. |
Release C-pillar panelling (1)
| • |
Unclip airbag panel (2)
|
| • |
Undo 2 clips and remove from guide
|
| • |
Leave C-pillar panelling hanging on belt (3)
|
|
|
|
| 6. |
Open the side wall panelling service flap
|
| 7. |
Detach striker pins (1), rear-seat back
|
|
|
|
| 8. |
Detach rear side-wall panelling
| • |
Unscrew 2 bolts (arrows)
|
| • |
Disconnect wiring harness connector.
|
|
|
| 9. |
Remove park pilot control unit
| • |
Remove control unit bracket
|
| • |
Disconnect 2 wiring harness plugs (3)
|
| • |
Remove park pilot control unit (2) from the park pilot control
unit bracket
|
|
|
|
Install
| 10. |
Install park pilot control unit
| • |
Insert control unit into park pilot control unit bracket
|
| • |
Connect 2x wiring harness plug
|
| • |
Insert park pilot control unit bracket
|
|
| 11. |
Attach rear side-wall panelling
| • |
Fix wiring harness plug
|
|
| 12. |
Attach striker pins, rear-seat back
|
| 13. |
Attach service flap, side-wall panelling
|
| 14. |
Attach C-pillar panelling
|
| 15. |
Install lower tailgate inner panelling
| • |
If present, clip in panel, Flex Fix System operating handle
|
|
| 16. |
Set rear-seat back into starting position
|
| 17. |
Insert luggage compartment mat
|
| 19. |
Program volatile memories
|
|
