Replace steering column switch module
Note: The steering
column switch module and the steering and ignition lock housing are
single-unit components.
Remove
3. |
Remove signal switch actuating lever
|
4. |
Remove windscreen wiper actuating lever
|
|
5. |
Disconnect column integration module (1)
• |
Release compact plug (2) and disconnect
|
• |
Release and disconnect steering and ignition lock wiring
harness plug (3, 4)
|
|
|
|
6. |
Remove steering column switch module with steering and ignition
lock (1)
• |
Unscrew bolt (2) using special tool CH-48829
Note: If no Torx-Plus
screw is fitted, replace the existing screw with a new Torx-Plus
screw.
|
• |
Pull steering column switch module (1) off steering column
Note: Ignition key to
position "I"
|
|
|
7. |
Detach lock cylinder for steering and ignition lock
Note: For replacement
of steering column switch module only.
|
Install
8. |
Attach lock cylinder for steering and ignition lock
|
9. |
Attach steering column switch module with steering and ignition
lock
• |
Push steering and ignition lock housing onto steering
column
Note: Until catch
latches audibly.
|
• |
Tighten bolt using special tool CH-48829
– |
Tightening torque 20 Nm .
|
|
|
10. |
Connect column integration module
• |
Connect and lock compact plug
|
• |
Connect and steering and ignition lock wiring harness plug
|
|
11. |
Instal windscreen wiper actuating lever
|
12. |
Remove signal switch actuating lever
|
13. |
Install steering wheel
|
15. |
Program volatile memories
|
|