Replace wiring harness, complete (model L 08)
Important: Repair
or replace wiring harnesses observing the safety regulations of
electrics/electronics .
Remove
|
3. |
Remove tail light - left side L 08
|
4. |
Remove tail light - right side L 08
|
5. |
Remove front panelling
|
6. |
Remove protective panelling, wheel installation, rear
|
7. |
Sensor - wheel speed - front/rear
• |
Disconnect wiring harness connector.
|
|
8. |
Lower fuel tank
• |
Disconnect wiring harness connector.
|
|
10. |
Remove sill inner panelling - both sides L 08
|
11. |
Remove rear seat - L 08
|
12. |
Remove the rear-seat back (single unit) - L 08
|
13. |
Remove front inner panelling of side panel - both sides
|
14. |
Remove centre console
|
15. |
Completely remove instrument panel padding
|
17. |
Remove headlining - L 08
|
18. |
Remove carpet base - L 08
|
19. |
Remove bulkhead closing part
|
20. |
Release wiring harness in engine compartment
|
21. |
Remove EPS steering column
|
22. |
Remove steering crossmember
• |
Detach steering crossmember with instrument panel wiring
harness
|
|
23. |
Apply position markers
|
24. |
Detach wiring harness, starting from tail and working to
bulkhead
|
25. |
Feed wiring harness through bulkhead and remove
|
|
Install
26. |
Install wiring harness
|
27. |
Fit steering crossmember
|
28. |
Fit EPS steering column
|
29. |
Install wiring harness in engine compartment
|
30. |
Install bulkhead closing part
|
32. |
Install moulded headlining
|
34. |
Completely install instrument panel padding
|
35. |
Install centre console
|
36. |
Fit front inner panelling of side panel - both sides
|
37. |
Install the rear-seat back, single unit
|
38. |
Install the rear seat
|
39. |
Install sill inner panelling
|
41. |
Lower fuel tank
• |
Fix wiring harness plug
|
|
42. |
Sensor - wheel speed - front/rear
• |
Fix wiring harness plug
|
|
43. |
Fit protective panelling, wheel installation, rear
|
45. |
Install tail light - left side
|
46. |
Install tail light - right side
|
48. |
Program volatile memories
|
|