Nova
Technical Data
Test brake light switch. After brake pedal distance of 20 ± 5 mm measured on pedal, the brake lights must illuminate.
Pressure when bleeding system with brake bleeder unit: 150 kPa (1.5 bar) pressure
Duration of leakage test in brake system: Approx. 10 minutes using Brake Pedal Tensioner
Check valve for vacuum line (tube): Arrows on the valve body must point toward the intake manifold
Dimensions of brake linings/pads (without lining plate):
Length x width x thickness in mm Lining quality: Disc brake linings: 98 x 44 x 11 Textar T 290 as of MY '92 for all other models diesel: Textar T 4037 as of MY '92 1/2 GSi: Jurid JU 171 Testar T 4037
Drum brake linings: 196 x 28 x 5 up to MY '87 as of MY '87 as of MY '90 1/2 lnlan 4202 Textar T 062 Pagid PA 557
Type of brake servo: 7" single diaphragm unit GMF, all except 15 D, 15 DT, C 16 NZ, E 16 SE, and C 16 SEI 8" single diaphragm unit, all 15 D, 15 DT, C 16 NZ, E 16 SE, C 16 SEI
Note: All vehicle types or models in the Technical Data, marked as export + version apply to the following countries: Belgium, Britain, France, Italy, Luxemburg, Netherlands, Norway, Austria, Sweden, Switzerland
Brake pedal distance: Measured at the pedal plate after depressing brake firmly 5 times with engine not running, so that brake serve control distance of approx. 1 mm is obtained - adjustable 6 mm to 9 mm.
Brake pedal bushing: Permissible inner diameter: 14.05 to 14.12 mm
Pedal ratio: up to MY '88: 10 S: 5.5 12 NC, 12 ST, E 12 N, 13 NB, C 13 N, 13 SB Left hand drive: 5.0 Right hand drive: 4.8 as of MY '88: all models
|