Special Service Tools
KM - 128-A Tension Gauge
To check V-belt tension
|
|
KM - 135 Adapter for
KM - 498 - B
To check engine oil pressure
|
|
KM-252-2-A Cables
To remove and install the engine
|
|
KM - 253 * Reamer 0.075 mm
Oversize
To ream valve guide
|
|
KM - 254 * Reamer 0.150 mm
Oversize
To ream valve guide
|
|
KM - 255 * Reamer 0.250 mm
Oversize
To ream valve guide
* No longer available
|
|
KM - 257 * Valve Retainer
To retain closed valve
|
|
KM - 261 Spring Compressor
To replace valve springs in conjunction with
KM - 257
|
|
KM-263-B Engine Lifter / Holder
To suspend engine with engine lifter and wire cable from
KM - 252 - 2 - A
* No longer available
|
|
KM-321 -A Splined Wrench
To remove and install flywheel
|
|
KM-328-B Remover
To remove the crankshaft needle bearing in conjunction with
KM - 469 - A
|
|
KM - 340-C Cutter Set
To grind and to correct the valve seat
|
|
KM - 348 Spring Compressor
To compress the valve spring with the cylinder head removed
|
|
KM - 412 Engine Overhaul Stand
To hold the removed engine
|
|
KM - 412 - 7- A Adapter
To hold engine in conjunction with KM - 412
|
|
KM - 427 Remover / Installer
To press out/in piston pins
|
|
KM - 469 - A Remover / Installer
To remove and install crankshaft needle bearing and seal
ring in conjunction with KM - 328 - B
|
|
KM - 470 - B Angular Torque
Wrench
To tighten cylinder head screws
|
|
KM - 498 - B Pressure Gauge
To check engine oil pressure in conjunction with
KM - 135
|
|
KM - 517 Locking Device
To lock the flywheel
|
|
KM - 526-A Clamp Set
To grip clutch assembly with 3 clamps
|
|
KM - 556- 1 - A Remover / Installer
To remove the transmission drive shaft
|
|
KM - 564 Remover / Installer
To install the transmission drive shaft
|
|
MKM - 596 Gauge
To measure the oil temperature
|
|
MKM - 597 Removing Pliers (replaced by
KM - 717)
To remove spark plug connector
|
|
MKM - 604 - B Torx Bit and Socket
Set
To remove and install Torx bolts
|
|
KM - 605 Adapter
To connect CO tester to vehicles with open loop catalytic
converter.
|
|
KM - 609 Electronic Kit I
Diagnosis of electrical and electronic systems
|
|
MKM - 610 Torque Wrench 1/2" Drive
Measuring range 30 - 130 Nm / 23 -
96 ft. lbf.
|
|
MKM - 611 Torque Wrench 3/8" Drive
Measuring range 10 - 60 Nm / 7 -
44 ft. lbf.
|
|
KM - 652 Locking Device
To lock flywheel
|
|
MKM - 667 Pressure and Vacuum Pump
To check vacuum cell for leaks
|
|
KM - 717 Remover Pliers
Remover pliers for spark plug connector
|
|
KM - J - 26792 Spark Tester
To check ignition spark
|
|