Rod Antenna, Service Install

Rod Antenna, Service Install

The rod antenna is mounted on the right front wing.

Drill hole for antenna bracket.

Drill hole diameter according to instructions for installing antenna.

Protect installation area against corrosion.

Drill hole for antenna cable in dash panel (diameter depending on enclosed grommet). Centre-punch mark is already provided.

Punch out pre -stamped opening in wheel well.

Drill 2 holes Æ 3.5 mm/0.14 in. in existing centre-punch mark.

Insert antenna in wing from below, align and fasten. Insert lower antenna guide and bolt on.

2 bolts

Lead antenna cable with grommet through dash panel and seal it.

Drill 3.5 mm/0.14 in. hole in wheel well.

Bolt ground lead on with toothed lock washer.

Lay antenna cable to radio and secure to dash panel.

Glove compartment should be removed for this.

Note:

To avoid noise, cover antenna cable in instrument panel area with self -adhesive foam strips.