Electronic chassis alignment must be carried out before
adjusting the toe-in and camber – see operation "Chassis
Alignment" or the brochure "Chassis, Wheel Suspension".
Adjust
Toe-in and camber adjustment of the rear axle is performed by
releasing both clamp connections (1) on the auxiliary control arm
of the relevant vehicle side and then turning the threaded pin
(2).
Tighten clamp connections on the auxiliary control arm only when
vehicle is under load – tightening torque 15 Nm / 11 lbf.
ft.
Chassis alignment values – see the relevant "Chassis
Alignment Values" brochure for the model year, or for vehicles up
to MY '99, see Technical Data "Chassis Alignment Values" in group
"E".
|