Damping bushings are removed from inside outwards.
Illustration shows right damping bushing:
Clamp damping bushing between KM-671 (3) and KM-833-4 (4) by
completely screwing on lock nut (5). Damping bushing is removed by
holding bolt (1) and turning nut (2).
Install
Insert new damping bushing with slotted hole (arrow) in
horizontal position. Damping bushings are pressed in from outside
inwards.
Clamp damping bushing between KM-671 (3) and KM-833-5 (6)
(collar side faces damping bushing) by completely screwing on lock
nut (5). Damping bushing is drawn in by holding bolt (1) and
turning nut (2), until KM-833-5 (6) contacts rear axle body.
Remove KM-671 and KM-833-5.
|