Install rear toothed belt cover – see operation "Toothed
Belt Cover – Rear, Remove and Install".
Attach coolant hose to thermostat housing and coolant hose to
coolant outlet port. Attach coolant hoses (1) and (2) to thermostat
housing.
Connect wiring harness plug to coolant temperature sender and
wiring harness plug to coolant temperature sensor.
Attach support (4) and shackle (3) to intake manifold and
alternator – tightening torque 20 Nm / 14.7 lbf. ft. Tighten
lower alternator fastening bolt – tightening torque 35 Nm /
25.8 lbf. ft.
Position ribbed V-belt – tension ribbed V-belt via ribbed
V-belt tension roller and KM-913-A. Note running direction of
ribbed V-belt. Close coolant drain bolt on radiator. Top up cooling
system – see operation "Cooling System, Top Up and Bleed" and
"Cooling System, Check for Leaks".
|