|
Dynamic Oil Level Control, Remove and Install
 Remove
|
Remove lower engine compartment cover.
Remove oil drain plug (1). Collect escaping engine oil.
Disconnect wiring harness connector (2) from dynamic oil level
monitor.
Remove dynamic oil level monitor attachment screws (arrows).
Remove dynamic oil level monitor.
 Clean
Clean sealing surfaces.
Re-cut attachment screw and oil pan threads.
|
|
Install
|
Attach oil drain plug and new oil seal to oil pan –
|
|
Tightening torque:
|
M12 x 1.5:
|
25 Nm / 18 lbf. ft.
|
|
|
M16 x 1.5:
|
45 Nm / 33 lbf. ft.
|
Insert dynamic oil level monitoring device with new seal ring.
Insert fixing bolts with adhesive sealing compound (black) -
tightening torque 5 Nm / 3.7 lbf. ft.
Connect wiring harness connector to dynamic oil level
monitor.
Install lower engine compartment cover - tightening torque 5 Nm
/ 3.7 lbf. ft.
Fill with specified amount of engine oil. Start engine and allow
to run until oil pressure telltale extinguishes. Turn engine off,
check oil level, correcting if necessary.
|
