|
Coolant Temperature Sensor, Remove and Install
|
Note: The coolant
temperature sensor is accessible from the underside of the
vehicle.
 Remove
Disconnect ground cable from battery.
Disconnect wiring harness plug (1) from coolant temperature
sensor and unbolt coolant temperature sensor out of coolant flange
(DIS ignition module adapter).
Coolant escapes – place collecting basin underneath.
|
|
Install
Bolt coolant temperature sensor with new seal ring into coolant
flange (DIS ignition module adapter) – tightening torque 10
Nm / 7.4 lbf. ft.
Connect ground cable to battery.
Top up and bleed cooling system – see operation "Cooling
System, Top up and Bleed" and "Cooling System, Check for
Leaks".
|
