vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F0: DATA LIST - Test Step 05 BOOST PRESSURE > < F0: DATA LIST - Test Step 03 FUEL TEMPERATURE

Digital Diesel Electronics DDE 2.1    F0:DATA LIST

 

No.

TECH 1-DISPLAY

Conditions for Checking

Nominal Value

Trouble Codes

Terminal

04

BOOST TEMPERATUR

Engine running at idle speed, operating temperature

10 to 70 °C/

50 to 158 °F

4.7 to 2.5 V

73, 74

52, 13

 

 

 

 

 

 

Trouble-shooting

Nominal Value

Cause of Fault:

(If nominal value is not attained)

 

·   Ignition ON

·   Disconnect wiring harness plug from charge air temperature sensor P29

·   TECH 1 parameter BOOST TEMPERATUR

4.5 to 5.5 V

(The corresponding trouble code is set and the replace-ment value of 4.98 V is used)

Voltage lower than 4.5 V

(TECH 1/ multimeter):

·   Short circuit to ground

from:      wiring harness plug for DDE control unit K70 Ter. 52

to:          wiring harness plug for charge air temperature sensor P29 Ter. 1

·   DDE control unit K70 defective

 

 

 

·   Using multimeter, measure voltage

from:      wiring harness plug for charge air temperature sensor P29 Ter. 1

to:          ground

4.5 to 5.5 V

Voltage greater than 5.5 V (multimeter):

·   Short circuit to voltage

from:      wiring harness plug for DDE control unit K70 Ter. 52

to:          wiring harness plug for charge air temperature sensor P29 Ter. 1

·   DDE control unit K70 defective

 

 

 

·   Bridge wiring harness plug for charge air temperature sensor P29 with electrically fused jumper

from:      charge air temperature sensor P29 Ter. 1

to:          ground

·   TECH 1 parameter BOOST TEMPERATUR

lower than 0.1 V

·   Short circuit to voltage/ circuit interruption

from:      wiring harness plug for DDE control unit K70 Ter. 52

to:          wiring harness plug for charge air temperature sensor P29 Ter. 1

·   DDE control unit K70 defective

 

 

 

·   Bridge wiring harness plug for charge air temperature sensor P29 with electrically fused jumper

from:      wiring harness plug for charge air temperature sensor P29 Ter. 1

to:          wiring harness plug for charge air temperature sensor P29 Ter. 2

·   TECH 1 parameter BOOST TEMPERATUR

lower than 0.1 V

·   Circuit interruption

from:      wiring harness plug for DDE control unit K70 Ter. 13

to:          wiring harness plug for charge air temperature sensor P29 Ter. 2

·   DDE control unit K70 defective

 

 

 

 

If nominal values are attained

·   Charge air temperature sensor P29 defective

 

 

 

 

 


Related Literature Units
-F2: TROUBLE CODE TABLE - Trouble Code 16 FUEL TEMPERATURE VOLTAGE LOW
-

F0: DATA LIST - Test Step 05 BOOST PRESSURE > < F0: DATA LIST - Test Step 03 FUEL TEMPERATURE