vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F0: DATA LIST - Test Step 15 A/C CUTOFF RELAY > < F0: DATA LIST - Test Step 13 A/C INFORMAT. SW

Digital Diesel Electronics DDE 2.1    F0:DATA LIST

 

No.

TECH 1-DISPLAY

Conditions for Checking

Nominal Value

Trouble Codes

Terminal

14

A/C CUT OFF REQ.

Vehicles with AC and AT:

 

-

24

 

 

Ignition ON

ACTIVE 12V

 

 

 

 

 

 

 

 

 

 

Engine running at idle speed, operating temperature

 

 

 

 

 

Actuate AC switch

INACTIVE

        0V

 

 

 

 

 

 

 

 

 

 

Vehicles with AC and MT:

 

 

 

 

 

Ignition ON

INACTIVE

        0V

 

 

 

 

 

 

 

 

 

 

Engine running at idle speed, operating temperature

 

 

 

 

 

Actuate AC switch

INACTIVE

        0V

 

 

 

 

 

 

 

 

Trouble-shooting

Nominal Value

Cause of Fault:

(If nominal value is not attained)

 

Note:

Test step 14 is divided into two parts:

a) For vehicles with air conditioning and manual transmission: carry out data list check a)

b) For vehicles with air conditioning and automatic transmission: carry out data list check b)

 

a) Vehicles with air conditioning and manual transmission:

 

 

·   Ignition OFF

·   Disconnect wiring harness plug from DDE control unit K70

·   Using multimeter, measure resistance

from:      wiring harness plug for DDE control unit K70 Ter. 24

to:          ground

 

lower than 2 W

·   Circuit interruption

from:      wiring harness plug for DDE control unit K70 Ter. 24

to:          ground

 

If nominal values are attained

 

·   DDE control unit K70 defective

b) Vehicles with air conditioning and automatic transmission:

 

 

·   Disconnect wiring harness plug from AT control unit K85

·   Ignition ON

·   TECH 1 parameter A/C CUT OFF REQ.

ACTIVE  12V

·   Short circuit to ground

from:      wiring harness plug for DDE control unit K70 Ter. 24

to:          wiring harness plug for AT control unit K85 Ter. 10

·   DDE control unit K70 defective

 

·   Bridge wiring harness plug for AT control unit K85 with electrically fused jumper

from:      wiring harness plug for AT control unit K85 Ter. 10

to:          ground

·   TECH 1 parameter A/C CUTOFF REQ.

INACTIVE 0V

·   Short circuit to voltage

from:      wiring harness plug for DDE control unit K70 Ter. 24

to:          wiring harness plug for AT control unit K85 Ter. 10

·   Circuit interruption

from:      wiring harness plug for DDE control unit K70 Ter. 24

to:          wiring harness plug for AT control unit K85 Ter. 10

·   DDE control unit K70 defective

 

 

If nominal values are attained

·   AT control unit K85 defective

 

 

 

 

 

 

F0: DATA LIST - Test Step 15 A/C CUTOFF RELAY > < F0: DATA LIST - Test Step 13 A/C INFORMAT. SW