|
Outrigger and/or Rubber Parts, Replace
 Remove
|
Raise vehicle. Pull 4 retaining clips out of outrigger and push
cover forwards.
|
|
|
Remove retaining clamps from pin. Pull pin out of gearshift
lever and shift rod. Unscrew outrigger from gearshift lever (4
screws). Unscrew both rear outrigger bolts from underbody.
|
|
|
Unscrew both outrigger bolts (arrows) from transmission. Tip
outrigger and remove.
|
|
|
Remove retaining bracket (3). Unclip rear rubber dampers (4 and
5) from outrigger.
Unscrew angle bracket (6) from outrigger and remove bushings
(2). Press rubber dampers (1) out of angle bracket.
|
|
Install
|
Press new rubber dampers (1) into angle brackets. Insert
bushings (2) in rubber dampers from below and screw angle bracket
to outrigger. Clip new rear rubber dampers (5) into outrigger and
clip in retaining bracket (3). Install new rear rubber damper (4)
on rubber damper (5).
Torque
Angle bracket (6) to outrigger – 15 Nm / 11 lbf. ft.
|
|
Install
|
Adhere foam ring (1) with lubricating grease to bearing ring of
gearshift lever.
|
|
Torque
|
Angle bracket of outrigger to transmission nose piece (arrows)
– 22 Nm / 16 lbf. ft.
|
|
Screw retaining plate of outrigger to vehicle underbody –
22 Nm / 16 lbf. ft.
|
|
Outrigger to gearshift lever housing (4 screws) – 10 Nm /
7.5 lbf. ft.
|
Caution
If the threaded plates for fastening the gearshift lever have
become displaced, remove and reinstall gearshift lever – see
"Gearshift Lever, Remove and Install" to correct position of
threaded plates.
|
|
Install
|
Insert pin in shift rod, gearshift lever and retaining clamp.
Fasten shift rod cover on outrigger with 4 clips.
Inspect
Lower vehicle, test shift all transmission gears. If necessary,
adjust gearshift lever see operation "Gearshift Lever, Adjust".
|
|
|
