|
 Remove
Remove engine cover.
Loosen closure plug (1) on fuel filter approx. two turns.
Actuate starter until fuel escapes free of bubbles at closure
plug. Seal closure plug. Collect escaping fuel.
Inspect
Whilst the starter is actuated, loosen all injection lines in
sequence at the injection nozzle holder with Line Wrench KM-812
(2), until fuel escapes at the injection lines.
Seal injection lines again – tightening torque 25 Nm /
18.5 lbf. ft.
Collect escaping fuel.
Install engine cover.
|
