If the above display did not
appear after programming, a fault occurred during programming. Perform the
following actions consecutively:
· If
a button of the infrared key transmitter is actuated, the relevant LED must
illuminate (if not, this means that the batteries in the infrared key
transmitter are flat);
· Read
trouble code;
· Perform
Quick Check F0: DATA LIST;
· Perform
Quick Check F5: ACTUATOR TEST;
· Reprogram;
· Perform
TECH 1 self - test;
· Check
TECH 1 cable for damaged insulation and shielding;
· Perform
programming using new control unit;
|