vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

F0: DATA LIST - Test Step 30 FUEL PUMP RELAY > < F0: DATA LIST - Test Step 26 VEHICLE SPEED

F0:DATA LIST

 

No.

TECH 1 Display

Conditions for Checking

Nominal Value

Trouble Codes

Terminal

27

DEC. FUEL 

Ignition ON

 

173

9/4

 

CUTOFF

Vehicle travelling constantly at a speed higher than 50 km/h (31 MPH):

 

INACTIVE

 

12-pin

 

 

Deceleration:

ACTIVE

 

 

 

 

With AT, drive in stage "1"

 

 

 

 

 

 

 

 

 

Notes for Trouble-shooting:

Nominal Value:

Cause of Fault:

(If nominal value is not attained)

 

·   Ignition OFF

 

 

·  Release and disconnect wiring harness plug from engine control unit K61 (MOTRONIC), K69 (SIMTEC) or K70 (DDE 2.1)

 

 

·   Ignition ON:

ACTIVE

·   Lead from 12-pin MID wiring harness plug Ter. 9 to engine control unit has short circuit to ground

 

 

·   MID defective

 

·   Connect contact in wiring harness plug for engine control unit for fuel consumption signal to ground

INACTIVE

·   Lead from 12-pin MID wiring harness plug Ter. 9 to engine control unit has short circuit to + battery voltage.

     (see following table):

 

·   Lead from 12-pin MID wiring harness plug Ter. 9 to engine control unit is interrupted

MOTRONIC M1.5.4    (20 SE, X 20 SE)      Ter. 32

 

·   MID defective

MOTRONIC M2.8.1    (X 25 XE)                 Ter. 32

 

 

                              (X 30 XE)                 Ter. 32

 

 

SIMTEC 56                  (X 20 XEV)              Ter. 14

 

 

DDE 2.1                       (25 DT)                     Ter. 49

 

 

 

 

 

Further possible faults

 

·   Engine control unit

 

 

 

 

 

 

 


Related Literature Units
-TABLE 2,TROUBLE CODES - Trouble Code 173 FUEL CONSUMPTION SIGNAL VOLTAGE LOW

F0: DATA LIST - Test Step 30 FUEL PUMP RELAY > < F0: DATA LIST - Test Step 26 VEHICLE SPEED