volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Audio System - Static Noise On AM Stations|Page 7276 > < Audio System - Static Noise On AM Stations
Page 2
background image

Install antenna cable and route along right side of vehicle from antenna to radio as follows:

Headliner, Removing

Warning:

Disconnect the battery ground (GND) cable before working on the electrical system.

Tip:

The removal and installation procedures may have to be modified slightly depending on equipment variations.

^

Obtain radio code and radio station presets.

A-pillar Upper Trim, Removing

^

Pull door inner seal -4- off A-pillar -6- and door openings.

^

Starting at top unclip trim -1- from -A- pillar -6- and pull out.

^

Disconnect speaker connector -3-.

Tip:

Before installing trim -1- check clips -5- and replace as necessary.

After installing the trim, check that the door inner seal is properly installed. 

^

Gently pry out make-up light with screwdriver and disconnect wiring connector.

Audio System - Static Noise On AM Stations|Page 7276 > < Audio System - Static Noise On AM Stations