Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
CD playback will skip if switches are not set correctly.
-
Always check/set switches prior to CD installation.
-
Switches must move completely to their end positions.
-
If switches need to be reset, loosen the securing screws, slide the switch towards the top into the "V" position and tighten screw.
-
Tightening torque: 2 Nm (18 in lb)
-
Cover selector switch openings with self adhesive seals (if supplied).
-
Attach both support brackets -1- to CD changer with screws -2-.
-
Tightening torque: 3 Nm (27 in lb)
-
Connect CD changer harness cable connector.
-
Route CD changer cable and clip connector -1- into the connector support piece located on the CD changer bracket -arrow-.
-
Slide CD changer into CD changer bracket from the top ensuring that the CD changer connector is securely located in the bracket - arrow-.
-
Install CD changer protective cover - 1-, ensuring the tips at the bottom of the cover align with their slots in the CD changer bracket.
-
Secure cover and bracket with screws from top.
-
Tightening torque: 3 Nm (27 in lb)
It is now necessary to code radio to enable CD changer operation and On Board Diagnostic (OBD) functions.
-
Code "Sound System" for CD operation using VAG 1551/1552 Scan Tool (ST)
-
Refer to Radio/CD changer owner's guide and check proper operation of CD changer.