Beetle L4-1.9L DSL Turbo (ALH) (1998)
Brake Caliper: Service and Repair
Brake Caliper Servicing
FN 3 Front Brake Calipers
FN 3 Front Brake Calipers , Servicing
Note:
^
Install all parts in repair kit.
^
New brake calipers are filled with brake fluid and are pre-bled.
^
When assembling, apply a thin coat of brake fluid to brake cylinders, pistons and seals.
1. Dust cap
2. Bleeder valve
^
Apply thin coat of brake fluid to threads before installing.
3. Cap
^
Insert in mounting bushing
4. Guide pin
^
25 Nm (18 ft. lbs.)
5. Mounting bushing
^
Insert into brake caliper housing
6. Brake caliper housing
7. Brake carrier
8. Retaining spring
^
Insert with both ends in holes in brake caliper housing
9. Piston seal
^
Removing and installing. See: Caliper Piston Removing and Installing/Front Brake/FN 3 Brake Caliper
10. Piston
^
Removing and installing. See: Caliper Piston Removing and Installing/Front Brake/FN 3 Brake Caliper
^
Apply thin coat of brake fluid to piston before inserting
^
Piston diameter: 54 mm (2.125 inch)
11. Dust boot
^
Do not damage when inserting piston