Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Remove seal using wedge 3409.
Caution:
^
When removing, use care to ensure that the cylinder is not damaged.
Installing
-
Apply thin coat of brake fluid on piston and piston seal.
-
Install piston seal in caliper housing.
-
Place dust boot with outer sealing lip on piston.
-
Hold piston in front of caliper housing and install inner sealing lip into grove in cylinder using wedge 3409.
-
Screw piston into housing by turning knurled wheel clockwise.
Note:
^
Install special tool 3272 with the collar (arrow) of the tool seated on the brake caliper
^
If the piston is difficult to move, use a 73 mm wrench on the flats (arrow -A-)
^
If the piston is pushed back with the piston resetting tool or by operating the foot brake, the automatic adjustment in the brake caliper is destroyed.
-
Install brake pads.
Brake Caliper, Pre-Bleeding