Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Cut wheel speed sensor wire in front of spliced connection with stripping pliers from wiring repair kit VAS 1978and remove faulty wiring.
-
Strip insulation at wiring end by 15 mm (5/8 inch) using stripping pliers from repair kit and fold over stripped wire portion.
-
Install new wheel speed wiring
-
Connect wheel speed sensor to speed sensor wiring.
-
Secure wheel speed sensor wire (arrows).
CAUTION!
^
Do not twist wires in the wheel well.
-
Connect wiring to wheel speed sensor.
-
Cut 2-pin connector at new wheel speed sensor wire (it installed) using the stripping pliers from the repair kit.
-
Strip 15 mm (5/8 inch) insulation off wire end and fold over stripped wire.
-
Connect wheel speed sensor wire using correct size connector from wiring repair kit VAS 1978.