Beetle L4-1.9L DSL Turbo (ALH) (1998)
Sealing Flange, Engine Rear: Service and Repair
Sealing flange and flywheel/drive plate, removing and installing
Note: For clutch repairs, Refer to Transmission and Drivetrain, Clutch, Service and Repair
1. 15 Nm (11 ft. lbs.)
2. Oil seal
^
Replacing, Refer to Seals and Gaskets, Engine, Front Crankshaft Seal, Service and Repair
3. Sealing flange, front
^
Must be located on dowel sleeves
^
Removing and installing, Refer to Timing Cover, Service and Repair
4. Engine block
^
Crankshaft,Refer to Crankshaft, Engine, Service and Repair
^
Pistons and connecting rods, disassembling and assembling, Refer to Piston, Engine, Service and Repair
5. Flywheel/drive plate
^
to remove and install flywheel, counter-hold using 3067
^
Drive plate, Refer to Transmission and Drivetrain, Automatic Transaxle, Flex Plate, Service and Repair
6. 60 Nm (44 ft. lbs.) plus additional 1/4 turn (90°) further
^
Always replace
7. Intermediate plate
^
Must be located on dowel sleeves
^
Do not damage/bend when assembling
8. Sealing flange with oil seal
^
Only replace as an assembly
^
Lightly oil sealing lip on oil seal