Beetle L4-1.9L DSL Turbo (ALH) (1998)
Technical Service Bulletin # 9700-01
Date: 000324
Electrical - Grounds/Identification Chart/Repair Tips
Group: 97
Number: 00-01
Date: Mar. 24, 2000
Subject:
Vehicle Grounds, Identification Chart and Tips on Repairs
Model(s):
1998, 1999 New Beetle
SUPERSEDES T.B. Group 97 Number 99-02, Dated March 29, 1999
Service
These pages contain a component ground identification chart which lists ground locations that have been integrated into the Repair Information System.
This bulletin also contains ground connection repair tips
Note:
-
Ground location in formation is shown in the Repair Manual CD ROM. To access:
-
Click "Library" button
-
Select appropriate model
-
Select "#" tab at top of page
Wire Harness, Repair
Note:
No other procedure or materials, other than those in VAS 1978, may be used for wire harness repairs, specifically soldering, wire nuts, generic repair
kits, etc.
Always review Safety Precautions in VAS 1978 Instruction Manual prior to performing any wiring harness repairs.
CAUTION!
Shielded wiring for components, such as speed sensors or knock sensors, may not be repaired, but must ALWAYS be replaced.
DO NOT use solder wire when repairing a wiring harness.
Only use approved methods and materials if wiring harness repairs are required.
Vehicle Grounds, Checking For Causes of Poor or No Ground
-
Inspect ground location for loose terminals (may indicate cap nut bottoming out before grounds terminals are secure).
-
Remove cap nut.