Beetle L4-1.9L DSL Turbo (ALH) (1998)
![background image](/volkswagen/beetle/l4-1.9l_dsl_turbo_(alh)/Page-1363002.png)
repairs.
CAUTION!
-
All wiring harness and connector repairs must only be performed using repair kit VAS 1978!
-
Before beginning wiring and connector repairs, determine and rectify the cause of damage, eg.: pinched between metal parts,
malfunctioning electrical consumers, corrosion due to water ingress etc.
-
Soldering is NOT permitted to any vehicle wiring.
-
Do not repair welded connections in wiring harnesses. If necessary, fabricate overlay wiring harness.
-
All shielded wiring (eg.: knock sensors, repair etc.) are Not to be repaired! Replace complete wiring harnesses as necessary.
-
When repairing airbag and seat belt tensioner wiring harnesses, use only prescribed terminals, connectors and wiring.
CAUTION!
-
Only the yellow repair cables and insulation tape supplied with VAS 1978 are to be used for wiring/connector repairs. The use of yellow
repair wires and yellow insulation tape identifies that a repair has taken place!
-
To prevent corrosion, avoid removal of ground connections at body fix-points.
-
When repairs are completed, always perform a functional check of the component or system. Where applicable, check and erase
Diagnostic Trouble Codes (DTCs) and set basic setting.
-
Additional information on removal and installation of electrical and related components.