Beetle L4-1.9L DSL Turbo (ALH) (1998)
Wastegate Actuator: Testing and Inspection
With Generic Scan Tool
Wastegate bypass regulator valve, checking
Recommended special tools and equipment e.g.:
-
VAG 1526 multimeter or VAG1715 multimeter
-
VAG 1594 connector test kit
Test sequence
-
Switch ignition off.
-
Disconnect connector (arrow) from wastegate bypass regulator valve.
-
Measure resistance between terminals of valve.
Specified value: 14...20 Ohms
If specified value is not obtained:
-
Replace Wastegate Bypass Regulator Valve -N75-.
-
Erase DTC memory of control module for Diesel-Direct fuel injection system, Diagnostic mode 4: Reset/erase diagnostic data. See: Computers
and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase
Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Switch ignition on.