Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Connect multimeter between cyl. 1 glow plug harness connector and Ground then repeat checking sequence for cylinders 2, 3 and 4.
-
Specification: Battery voltage for approx. 20 secs.
If voltage present
-
Switch OFF ignition.
-
Disconnect harness connectors from glow plugs.
-
Connect VAG 1527B Voltage tester lead to Battery + using jumper wire from VW 1594 adaptor kit.
-
Touch tester probe to each glow plug, one after the other.
-
If diode lights up: glow plug OK
-
If diode does not light up: replace glow plug
-
Remove and install glow plugs using 3220 swivel socket.
-
Tightening torque: 15 Nm (11 ft lb)
-
Erase DTC memory. Refer to "Displaying and Reading Trouble Codes/With Manufacturers Scan Tool/DTC Memory Checking and Erasing",
See: Computers and Control Systems/Testing and Inspection
-
Set the Readiness code. Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Setting Readiness Code" See: Computers and Control
Systems/Testing and Inspection