Beetle L4-1.9L DSL Turbo (ALH) (1998)
/Page-1532002.png)
-
Replace with existing three 0.35 mm wires from steering column -arrow- in correct positions.
Note:
^
During terminal extraction, primary lock tab(s) may have been pressed into terminal.
^
Primary lock tab(s) should be straight and stand away from the terminal. Straighten using sharp edge to carefully lift tab to achieve approximately a
30° angle.
-
To install into new connector, push terminal into appropriate socket as far as possible.
-
Push violet secondary lock mechanism into connector housing until it snaps into place.
-
Pull gently on terminals to ensure proper engagement.
Install driver airbag unit
-
Connect electrical connector to back of airbag unit.
-
Connect VAS 5051 Diagnostic Tool and verify that no DTC's are stored in fault memory.
See Repair Manual, Airbag System OBD for detailed information.
